Oven repair in King City. Bake at the temperature you actually set.
Wall ovens, range ovens and double ovens, gas or electric, repaired in your kitchen by one of our three certified local techs. We cover King City, Nobleton and Schomberg, 7 days a week from 7am to 11pm. The service call and diagnosis cost you nothing when you go ahead with the repair, and the labour is covered for 3 months.
Before you call: note the exact error code on the display and whether the oven heats at all. Those two details often tell us which part to bring on the first visit.
Wall, range and double
Open 7 days, 7am to 11pm
$0
Service call with repair
The diagnosis is free when you approve the oven repair we quote.
3 months
Labour warranty
Same fault back within 3 months? We come back and fix it with no labour charge.
7 days
7am to 11pm
Evening and weekend slots, so a dead oven never waits a week.
3
Certified local techs
Insured techs based in King Township, so we're usually a short drive away.
Oven brands we repair in King City
Wall ovens and range ovens from the major makers, gas and electric.
‹1 / 2
2 / 2›
Swipe to see more brands
Oven repair in King City
Match your oven fault to the cause, then book the repair
These four cover almost every oven call we take in King City. Under each are the causes our techs usually find once the back panel is off, whether it's a wall oven or the oven under your cooktop.
Wall ovensRange ovensDouble and built-inGas and electric
Why is my oven not heating?
An oven that stays cold, or takes an hour to reach 350, usually has a failed heating part rather than a broken control.
Burnt-out bake or broil element
On an electric oven you can sometimes see a blister or a break in the element. Just as often it looks perfect and still fails a continuity test.
Gas igniter too weak to open the valve
On a gas oven the igniter has to glow hot enough to trip the safety valve. As it ages it glows but never quite gets there, so you smell a little gas and get no flame.
Failed thermostat or control board
If the oven heats but never shuts off, or never starts at all, the sensor or board may not be telling it what to do.
Check this first: On an electric oven, watch the elements with the door open for a few seconds. A section that never glows orange is a strong clue.
Why does my oven burn or undercook food?
When cakes brown on one side and stay raw on the other, or everything needs an extra ten minutes, the oven is not holding the temperature on the dial.
Faulty temperature sensor
This thin probe inside the cavity tells the control how hot things are. When it drifts, your oven can sit 50 degrees off without ever showing an error.
Worn door seal or sagging door
Heat escaping around the door leaves the front of the oven cooler than the back. A gasket that no longer springs back is usually to blame.
Convection fan not running
On a convection oven, a fan that has stopped leaves hot and cold pockets, so one tray bakes while the other doesn't.
Check this first: An oven thermometer from the hardware store costs very little. Set 350, wait 20 minutes and see what it actually reads before you call.
Why is my oven door locked or stuck shut?
Most ovens lock the door during a self-clean and release it once things cool. When that release fails, the door stays shut with no obvious way in.
Self-clean cycle interrupted
The self-clean runs very hot and locks for safety. If it's cut short or the latch motor sticks, the door can stay locked long after the oven is cool.
Failed door latch motor or switch
The small motor that drives the latch wears out. It's a common repair and usually far cheaper than people expect.
Control board after a self-clean
Self-clean heat is hard on the electronics behind the panel. It's the most common time for a board or thermal fuse to give out.
Check this first: Let the oven sit unplugged for an hour, then power it back on. Many locks release once the control resets and the cavity is fully cool.
Why is my oven showing an error code?
F-codes and beeping panels look alarming, but most point to one specific part, and the code tells us where to start.
Sensor or probe faults
A whole family of codes simply means the control has lost a sensible reading from the temperature sensor. The part itself is inexpensive.
Door lock faults
Codes tied to the latch usually appear during or after a self-clean, and go hand in hand with a door that won't open.
Control board or touchpad faults
Buttons that respond on their own, a panel that goes dark, or a code that returns after every reset generally point to the board.
Check this first: Write the code down exactly as it appears, letters and numbers both. Tell us when you book and we'll often arrive with the part already on the van.
A word about the self-clean cycle
Self-clean runs the cavity far hotter than any recipe ever will, and that heat is what finishes off latches, thermal fuses and control boards. If you use it, run it well before a holiday rather than the night before, open a window, and take the racks out unless the manual says they can stay. Wiping the oven down by hand is easier on it. If you smell gas at any point, leave the house first and call 911 or Enbridge Gas at 1-866-763-5427 from outside.
Certified and insured techs3-month labour warranty$0 service call with repair
What King City homeowners say about our oven repairs
TL
Theresa L.
3 days ago
★★★★★
Ran the self-clean the night before company and of course the door locked shut and stayed that way. I was mortified. They came out the next morning and had it open and working before anyone arrived.
Posted on Google
NB
Nathan B.
6 days ago
★★★★★
Wall oven, built into the cabinets, and I was worried about the surround. Careful work, nothing marked.
Posted on Google
PO
Pam O.
last week
★★★★★
Shortbread was coming out dark on the bottom and pale on top every single time. I'd genuinely started to think I'd forgotten how to bake. The oven was running well off what the dial said.
Posted on Google
RQ
Raheem Q.
2 weeks ago
★★★★★
Error code on the display that meant nothing to me. One phone call, they knew the part, and brought it with them. Done in one visit.
Posted on Google
JS
Joanne S.
a month ago
★★★★★
Straightforward and fairly priced. No charge for the visit because we went ahead with the repair.
Posted on Google
CD
Curtis D.
5 weeks ago
★★★★★
Gas oven stopped lighting. It would tick and glow and then just nothing. He explained exactly what was failing in a way I could actually follow.
Posted on Google
LM
Lina M.
2 months ago
★★★★★
Our double oven had one side working and one side dead for about six months. We'd just been managing around it. Should have called much sooner, it wasn't a big job.
Posted on Google
FW
Frank W.
3 months ago
★★★★★
On time, tidy, polite. Not much more you can ask for.
Posted on Google
DR
Deepa R.
4 months ago
★★★★★
Booked on a Sunday evening not expecting much. Somebody actually answered and we had a visit set for Monday.
Posted on Google
GH
Gordon H.
5 months ago
★★★★★
He told us the honest truth about the age of our oven and what was likely to go next, without any pressure either way. We fixed it and it's been fine.
